Hollow Stock Push Button Base - GTHM198
WARNING: Some of these products can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov
The perfect solution for installing a push button base into thin walled stocks it is not thick enough to support a thread base alone. It's held in place on the inside of the stock by a mating panel nut.
Full-Rotation
Black-Oxide Finish
9/16˝-18 Thread
Worked great on my Beretta A300 Ultima Patrol.
Needed a solution for my Mossberg 930 to give me options for my QD slings. Amazon had these in stock, or I would have bought them direct here. Found a mounting location on the hollow stock past the butt pad screw posts. See attached photos. Drilled a 1/8” pilot and then a 1/2” hole. Threads were a little larger but had no issue just using the cup button as a tap for install. Added a bit of blue Loctite to the threads once it was through the stock to help ensure that the knot would not back off. Completely happy. What a great solution.
easy install. hardest part was deciding where to mount it
I was between multiple Mount options and bought about 4 of them. I ended up using this one but didn’t get the nut on the back. I would love to see an extended variation as well. It would make more measurement work for the end user though and some aren’t up for it. We’ll have a video on YT at some point.
Worked perfectly on my Moss 930 stock. Didn’t tap the plastic and just used the nut and locktite and it’s SOLID.